Up to now I can find three unexpected and I changed one of it
1, no picture form UI
2, openag_brain.service not run via reboot
give the full path to
openag_brain run after reboot
sudo systemctl stop openag_brain.service
sudo systemctl start openag_brain.service
That’s I can do it
- From the source :water level sensors,
line 18 ,19 is it to be D3 water lever low and D4 water level high ?
I used pull-up resistor for them only the data_3 sensor dip into water , the K12 pump_5_water will goes out , data_4 sensor will not cause any change to 16way relay
K6,K7 always on after the system start and RUN
K5 always on after I touched AIR FLUSH.
K2 RED LIGHT (PWM?)
K4 BLUE LIGHT (PWM?)
K3 WHITE LIGHT (PWM?)
K14 WATER PH toggle (PH sensor inside storage liquid
K12 Work with D3 sensor and WATER LEVEL
K1and K9 AIR TEMPERATURE
K8,K10,K11,K13,K14,K15,K16 not yet light up
D9, D10 not connect to anything.